CNC four-axis circular wood pusher saw is a powerful tool in wood processing. The use of circular circular rail and ball steel structure created by Zhou in China can ensure that the processed products achieve high quality and standard design, solve the problem of degumming of the guide rail, and maintain good accuracy in long-term use. The mobile worktable is made of high strength extruded aluminium alloy with streamlined integral design and surface oxidation treatment. It has high strength and no distortion. 2. Rotating main parts at the entrance of log pusher saw, low temperature rise, low noise and low vibration. The sawing group can tilt 0-45 degrees, which is convenient and practical. The fuselage, fixed worktable and mobile pusher are aged to ensure long-term stability and high accuracy.
Four-axis circular wood pusher saw equipment adopts a new structure and a number of new technologies. According to the characteristics that the diameter of logs in fast-growing forests in South China is mostly 15-40 cm, this equipment can saw logs, semi-logs and square logs within this diameter. It can cut a log into several pieces of pre-adjusted specifications at one time. It has high automation, high precision and high precision. Because the thickness of saw blade used is 3.2-3.7 mm, compared with the thickness of 4.5 mm of general single-blade saw blade, the manufacturer supplies large-scale circular wood pusher saw square wood pusher saw 4 m pusher saw circular wood multi-blade saw, sawing loss is 46% lower than other sawing machines, on the contrary, the yield is as high as 70% to 82%, wood utilization ratio is about 30% higher than other kinds of sawing machines. The cutting process is stable, the same thickness precision of the sawn board, the smooth and even surface are high, and the production efficiency is improved. When we change the push-table saw blade, we should carefully consider that the width of the saw blade should be in line with the width of the wheel surface, and not be too wide than that of the wheel surface. The saw blade is clamped in the center of the saw clip. The bottom of the serrated teeth should be kept in a non-stop line with the outer edge of the saw clip. The saw blade can not be clamped too tightly. It should be able to slide in the center of the saw clip. Both sides should be free, with each side about 0.04-0.08 mm free. The back of the saw blade is about 0.8mm away from the pulley. If the saw blade has already fought against the pulley when it idles, that is to say, the saw blade is backward, or the pulley is forward, or the tension of the saw blade is dissipated, the saw wheel or pulley should be adjusted, or the saw blade should be unloaded before checking and rolling. The tensioning device of saw blade is divided into spring and heavy hammer. This machine is a spring device. The base tension should be determined by the width, thickness and speed of the saw blade. Usually, finger-pressing saw blades are accepted. According to the left and right bending degree of the saw blades, it is determined whether the tension force is proper or not. The manufacturer supplies large circular wooden push-table sawing square wooden push-table sawing four-meter push-table sawing circular wooden multi-blade sawing.